Getting Started - Husqvarna Viking Designer SE User Manual

Getting Started

To enter embroidery mode, touch
the top of the Interactive Designer screen. The
green background in the button indicates that
Embroidery Mode is active. Make sure that
at the bottom of the screen is pressed, indicating
that Interactive Designer Customizing is active.
1. Touch and select a design. Designer SE
automatically selects the smallest hoop size
that fi ts the design.
2. Touch to open the Embroidery Advisor
for recommendations for stabilizer, thread,
and needle for the selected fabric.
3. Slide on the embroidery unit. A pop-up
prompts you to clear the embroidery area
for positioning. Touch
move the embroidery arm to ready position.
4. Slide on the hoop. Make sure that the hoop
attached matches the hoop size shown on
the screen or change hoop size by touching
and selecting correct size from the list
(see page 4-5).
5. Touch at the bottom of the screen to go
to Interactive Designer Embroidery to stitch
out your design.
6. Touch or touch the foot control to
start the embroidery. The machine detects
the hoop and starts embroidering. After a
few stitches, the machine stops and a pop-up
appears on the screen prompting you to cut
the thread ends. Cut the thread and touch
to continue embroidering.
7. When the fi rst color is completed, your
Designer SE stops. A pop-up appears,
prompting you to change color. Re-
thread with the next color and continue as
described in section 6 above.
8. When the embroidery is completed, your
Designer SE stops and a pop-up informs you
that your embroidery is fi nished. Touch
to remove your design from the screen or
touch to get back to your embroidery
with the possibility to save it or stitch it
again. The hoop is brought back to the start
position for the fi rst design color.
3-6
Set to Embroider
at
to calibrate and
1.
2.