Table of Contents
Advertisement
Placing the Bobbin in the Machine
1. Remove the bobbin cover by sliding it
towards you.
2. Place the bobbin in the bobbin case with the
markafacing up and the thread to the left
of the bobbin. The bobbin will then rotate
counter clockwise when pulling out the
thread.
3. Place your fi nger on the bobbin to keep it
from turning as you pull the thread fi rmly to
the right and then to the left into the tension
spring (a) until it "clicks" into place.
4. Continue threading around (b) and to the
right of the thread cutter (c). Replace the
cover (1). Pull the thread to the left to cut it
(2).
Set it Up
1.
3.
b
2.
10 15
4.
b
a
c
2
1
1-15
Advertisement
Table of Contents
