Set Menu - Husqvarna Viking Designer SE User Manual

Set it Up

Set Menu

In the Set Menu, all machine settings are
displayed and set. You can override automatic
settings and make manual adjustments. Simply
check the boxes to activate a function, or touch
the corresponding buttons to open settings.
Sensor Foot Auto
The default setting is "auto". Stopping with the
needle down the presser foot raises to pivot
position. On "manual" (box is not checked),
the foot stays on the fabric when stopping with
needle down. Touch to raise foot to pivot
position.
Sensor Foot defaults to active when Designer SE
is turned on.
FIX Auto
On auto (default) setting, each stitch begins with
fi x tie-off stitches. On manual, touch to
tie off.
FIX Auto is always active when Designer SE is
turned on.
Selective Thread Cutter Auto
On auto (default) setting, the threads are cut
automatically and the presser foot raises after
a Sensor buttonhole or eyelet is sewn, at color
changes or when an embroidery is fi nished. On
manual, threads are not cut after these stitches.
Twin Needle
Opens a list for twin needle width selection.
When the twin needle size is selected, the width
of all stitches is limited for the needle size to
prevent needle breakage. The adjustments are
kept until you set the twin needle selection to
"off". When a twin needle size is set, a pop-up
is shown when turning on your Designer SE,
and another one when selecting a stitch that is
too wide for the set twin needle size. The stitch
width is automatically adjusted to fi t the twin
needle setting. Close the pop-up by touching
.
1-25