Keypad Configuration Mode; Keypad Installation; Configuring The Keypads - NAPCO Gemini GEM-P1632 Programming Instructions Manual

KEYPAD CONFIGURATION MODE

This section will focus on configuring the GEM-RP2ASe2/GEM-K2AS, GEM-RP3DGTL/GEM-K3DGTL and GEM-
RP4RFC/GEM-K4RF Keypads. If there is more than one keypad in the system, only Keypad No. 1 may be used for
programming. For ease of programming, it is recommended that a GEM-RP1CAe2 or a GEM-K1CA be selected as
Keypad #1 (see WI897 for Programming Instructions).

KEYPAD INSTALLATION

Each keypad must be assigned an address number (1–7) and each requires its own configuration procedure (see
CONFIGURING THE KEYPADS, which follows, and DIRECT ADDRESS KEYPAD AREA OPTIONS). At least 1
keypad must be used; only 1 is required for a single-area Commercial Burglary installation.
GEM-RP2ASe2/GEM-K2AS - are utility LCD keypads combining several preset LCD words with a limited
message line. NOTE: Due to space constraints, available messages are abbreviated and will scroll
automatically.

CONFIGURING THE KEYPADS

Configuring the GEM-RP2ASe2/GEM-K2AS, GEM-RP3DGTL/GEM-K3DGTL and GEM-
RP4RFC/GEM-K4RF Keypads
Up to 7 GEM-RP2ASe2/GEM-K2AS, GEM-RP3DGTL/GEM-K3DGTL and/or GEM-RP4RFC/GEM-K4RF keypads may
be connected to the panel (Keypads 1–7). Each must be configured for a keypad address. In addition, the keypad may
be configured to disable (a) touchpad backlight; (b) LCD backlight; and (c) entry sounder. Keypads are configured by
the proper selection of jumpers. Refer to the label on the circuit board insulation paper for jumper locations and a
summary of settings.
KEYPAD ADDRESS
If more than one keypad is installed:
!
Each must be assigned a unique address (that is, no two keypads
may be numbered alike).
!
Keypads must be addressed consecutively (that is, missing
numbers are not permitted).
!
Only Keypad No. 1 may be used for programming. (However, for
ease of programming, it is recommended that a GEM-RP1CAe2/
GEM-K1CA be selected as Keypad #1).
Assign the keypad address number by selecting Jumpers J1–3 in
accordance with the table at right.
*Note: (1) Keypads are factory supplied with no jumpers installed and as such are automatically configured as Keypad
No. 1. (2) Only one keypad in the system may be configured as Keypad No. 1, otherwise none will function.
TOUCHPAD BACK LIGHT
Cut Jumper A to disable touch pad backlighting to conserve 11mA standby current.
LCD BACKLIGHT
Cut Jumper B to disable LCD backlighting.
DISABLE SOUNDER
Cut Jumper C to disable the sounder. (Do not disable in UL applications.)
L
NAPCO Security Systems
KEYPAD KEYPAD ADDRESS SETTING
NUMBER 1 2
1 OFF or OFF OFF
ON*
2 OFF ON
3 ON ON
4 OFF OFF OFF
5 ON OFF
OFF
6 ON
7 ON ON
X
GEM-P1632 Programming Instructions
!
Page 43
PARK
3
OFF
STORE SPARE
OFF
JUMPER AT THIS
POSITION
ON
ON
ON