Keypad Configuration Mode - NAPCO Gemini GEM-P3200 Installation Instructions Manual

WI817B 11/98

KEYPAD CONFIGURATION MODE

GEM-RP1CA/1CAe/1CAe2
KEYPADS
Move Jumper JP5 * from Pins 1-2 to Pins 2-3
(Wait about 15 seconds: " 
  
 
Enter Factory Code:



Press button
Configure:
Keypad Beep ON/OFF
Entry Sounder
Keypad Address 01
New Compat# 000 **
EZM Address 00
Zone Response 00
 
Program Control Message# 1
Press button
("  
    
   ")
Return Jumper JP5 * from Pins 2-3 to Pins 1-2
("       ")
* JP5 is located at the top-right corner of the circuit board.
** If a Compatability Number other than "0000" is programmed, "   %



" is displayed.
NAPCO Security Systems

   ")
GEM-RP2AS/RP2ASe/RP2ASe2
KEYPADS
Configure:
Keypad Address (Jumpers J1-J3)
Touchpad Backlight (Jumper A)
LCD Backlight (Jumper B)
Entry Sounder (Jumper C)
GEM-P3200 Installation Instructions
Page 59