Keypad Configuration Mode; Keypad Installation; Configuring The Keypads - NAPCO Gemini GEM-X255 Programming Instructions Manual

!
Page 52

KEYPAD CONFIGURATION MODE

This section will focus on configuring the GEM-RP1CAe2 and GEM-RP2ASe2 Keypads. If there is more than one keypad in the
system, only Keypad No. 1 may be used for programming.

KEYPAD INSTALLATION

Each must be assigned an address number (1–15) and each requires its own configuration procedure (see CONFIGURING THE
KEYPADS, which follows, and DIRECT ADDRESS KEYPAD AREA OPTIONS). At least 1 keypad must be used; only 1 is required
for a single-area Commercial Burglary installation.
GEM-RP1CAe2 - is a 2-line combination fire/burglary/access keypad capable of supporting 4 EZM zones and a PGM output. A
GEM-RP1CAe2 is recommended for use as Keypad #1.

CONFIGURING THE KEYPADS

A total of up to 15 keypads may be connected to the panel.
Configuring the GEM-RP1CAe2 Keypad
Each GEM-RP1CAe2 keypad must be configured for (a) keypad tactile beep; (b) entry sounder; (c) keypad address; (d) compatibility
number; (e) EZM address; and (f) zone response.
To enter the GEM-RP1CAe2 Configuration Mode:
1. Move jumper JP5 (located at the upper-right corner of the control panel board) from Pins 1-2 (top two) to Pins
two). NOTE: See Wiring Diagram on page 80.
2. After about 15 seconds, the display will read "XX OUT OF SYSTEM", where XX indicates the keypad address.
3. Press 11123 A
for all keypads.)
KEYPAD BEEP ON
Press the A button to continue or press the
ENTRY SOUNDER ON
KEYPAD ADDRESS 01
To assign the keypad number, proceed as follows:
1. Enter the assigned keypad number 01–15, then press the
beep; an invalid number will be rejected by a long beep.
2. Press the A button to continue or press the
X
GEM-X255 Programming Instructions
and proceed as follows. (Repeat the following procedure
Keypad Tactile Beep
Upon entering the Keypad Configuration Mode, "KEYPAD BEEP ON" will be displayed,
indicating that the tactile beep, which sounds when any button is pressed, is on. To
turn off the tactile beep, press the
beep on and off).
C button to exit.
Entry Sounder
To turn off the keypad sounder during entry time, press the
will toggle the tactile beep on and off). Press the
press the C button to exit.
Keypad Address
If more than one keypad is installed, each must be assigned a unique keypad
address (that is, no two keypads may be numbered alike):
!
keypads must be numbered consecutively (missing numbers are not permitted)
!
only Keypad No. 1 may be used for programming.
J
button to save. A valid number will be acknowledged by a short
C button to exit.
J J
button (the button will toggle the tactile
J
button (the
A button to continue or
L
NAPCO Security Systems
WI1092B 9/02
GEMINI
SYSTEM ARMED
KEYPAD BEEP ON # OF ZONES IN AREA 1
01/01/97 12:00AM
ENTER # ZONES X X
NEXT/YES
A 1 2 3 E
D
PRIOR/NO
B 4 5 6 F
AREA
C 7 8 9 0 G
COMPUTERIZED SECURITY SYSTEM
R
2-3 (bottom
NORMAL
KEYPAD
CONFIGURE
J
button