90
Opening and closing
Changing the battery
SEAT recommends you ask a specialised workshop to replace the battery.
The battery is located to the rear of the vehicle key, under a cover.
Changing the battery
● Unfold the vehicle key shaft ⇒ p age 88.
● Remove the cover from the back of the vehicle key
tion of the arrow ⇒ .
● Extract the battery from the compartment using a suitable thin object
⇒ F ig.
47.
● Place the new battery in the compartment as shown
in the opposite direction to that shown by the arrow ⇒ .
● Fit the cover as shown
in the opposite direction to that shown by the arrow until it clicks into place.
CAUTION
● If the battery is not changed correctly, the vehicle key may be damaged.
● Use of unsuitable batteries may damage the vehicle key. For this reason,
always replace the dead battery with another of the same voltage, size and
specifications.
Fig. 46 Vehicle key:
opening the battery com-
● When fitting the battery, check that the polarity is correct.
partment
For the sake of the environment
Please dispose of your used batteries correctly and with respect for the envi-
ronment.
Synchronising the vehicle key
If the button
Fig. 47 Vehicle key:
sible that the vehicle can no longer be locked or unlocked using the key. In
removing the battery
this case, the key must be resynchronised as described below:
● Unfold the vehicle key shaft ⇒ p age 88.
● If necessary, remove the cover from the driver door lever ⇒ p age 97.
● Press the button
vehicle.
● Open the vehicle within one minute using the key shift. The key has
been synchronised.
⇒ F ig. 46
in the direc-
● If necessary, fit the cap.
⇒ F ig.
46, pressing it onto the vehicle key casing
is pressed frequently outside of the vehicle range, it is pos-
on the vehicle key. For this, it must remain with the
⇒ F ig.
47, pressing