Seat Leon Owner's Manual page 114

When a car that is manufactured in a country that drives on the right travels
to a country that drives on the left (or vice versa), it is normally necessary to
cover part of the headlight bulbs with stickers or to change the adjustment
of the headlights to avoid dazzling other drivers.
In such cases, the regulations specify certain light values that must be com-
plied with for designated points of the light distribution. This is known as
"Tourist light".
The light distribution that the halogen and full-LED headlights of the SEAT
Leon range have, allows the specific "tourist light" values to be met without
the need for stickers or changes in the settings.
Note
"Tourist light" is only allowed temporarily. If you are planning a long stay in
a country that drives on the other side, you should take the vehicle to an
Authorised Technical Service to change the headlights.
"Coming home" and "Leaving home" function (guidance
lights)*
The "Coming home" function should be switched on manually. However the
"Leaving home" function is automatically controlled by a photo sensor.
Safety First Operating instructions
"Coming home" Necessary operations
– Switch off the ignition.
– Briefly flash the headlights for approximately one sec-
ond ⇒ p age 107.
To switch sys-
tem on: The "Coming home" lighting comes on when the driver
door is opened. The delay in switching off the headlights
is counted from when the last door or rear lid is closed.
– Automatically at the end of the delay period.
– Automatically, if 30 seconds after coming on, a vehicle
The system
door or the rear lid remains open.
switches off:
– If the light switch is turned to position .
– If the ignition is switched on.
"Leaving home" Necessary operations
To switch sys- – Unlock the vehicle when the light switch is in position
tem on:  and the photo sensor detects darkness.

– Automatically, at the end of the delay period.
The system – When the vehicle is locked.
switches off: – When the light switch is turned to position .
– When the ignition is switched on.
Note
● In the Easy Connect system, the duration of the lighting can be adjus-
ted, and the function activated and deactivated ⇒ p age 79 using the button
and the function button
Setup

● When the "Coming home" function is activated, a tone can be heard
when the driver door is opened to warn that the light remains switched on.
Practical Tips
Lights and visibility
.
Technical specifications
113
