Seat Leon Owner's Manual page 77

76 Driver information system
Multifunction display memory
The multifunction display is equipped with three memories that work auto-
matically: MFD from departure, MFD from refuelling, MFD total calculation.
On the screen display, you can read which memory is currently displayed.
To change between memories with the ignition on and the memory shown,
press the button on the windscreen wiper lever or you can also

change between memories using the button
ing wheel.
Menu Function
Display and storage of the values for the journey and the
consumption from when the ignition is switched on to
when it is switched off.
MFD from de- If the journey is continued in less than 2 hours after the ig-
nition is switched off, the new data is added to the data al-
parture
ready stored in the memory. The memory will automatically
be deleted if the journey is interrupted for more than two
hours.
Display and storage of the values for the journey and the
MFD from re-
consumption. By refuelling, the memory will be erased au-
fuelling
tomatically.
The memory records the values for a specific number of
partial trips, up to a total of 19 hours and 59 minutes or 99
MFD total cal- hours and 59 minutes, or 1999.9 km (or miles) or 9999 km
(or miles), depending on the model of instrument panel.
culation
On reaching either of these limits
matically erased and starts to count from 0 again.
a)
It varies according to the type of instrument panel fitted.
Erasing a memory manually
● Select the memory that you wish to erase.
● Press and hold the button
button on the multifunction steering wheel for about 2 seconds.

on the multifunction steer-

a)
, the memory is auto-
on the windscreen wiper lever or the

Personalising the displays
In the Easy Connect system you can adjust which of the possible displays of
the MFD can be shown on the instrument panel display with the button
⇒ p age 79.
and the function button
Setup
Displays
Menu Function
The current fuel consumption display operates through-
Current fuel con-
out the journey, in litres/100 km; and with the engine
sumption
running and the vehicle stopped, in litres/hour.
After turning on the ignition, average fuel consumption
in litres/100 km will be shown after travelling approxi-
Average fuel con-
mately 100 metres. Otherwise horizontal lines are dis-
sumption
played. The value shown is updated approximately ev-
ery 5 seconds.
Approximate distance in km that can still be travelled
with the fuel remaining in the tank, assuming the same
Operating range
style of driving is maintained. This is calculated using
the current fuel consumption.
This indicates the hours (h) and minutes (min) since
Journey duration
the ignition was switched on.
Distance covered in km (m) after switching on the igni-
Distance covered
tion.
The average speed will be shown after a distance of ap-
proximately 100 metres has been travelled. Otherwise
Average speed
horizontal lines are displayed. The value shown is up-
dated approximately every 5 seconds.
Digital display of
Current speed displayed in digital format.
speed
If the stored speed is exceeded (between 30 - 250 km/
Speed warning at
--- km/h or Speed h, or 1 - 155 mph), an audible warning is given togeth-
er with a visual warning.
warning at --- mph

