Selecting The Location For The Indoor Unit; Installation Of Indoor Unit; Position Of Suspension Bolt - Panasonic R410A Service Manual

1

SELECTING THE LOCATION FOR THE INDOOR UNIT

Required Minimum Space for Installation and Service.
Provide a check port on the piping side ceiling for repair and maintenance.
● Install the indoor unit once the following conditions are satisfied and after receiving the customer approval.
1. The indoor unit must be within a maintenance space.
2. The indoor unit must be free from any obstacles in path of the air intet and outlet, and must allow spreading of air throughout the
room.
* If the height from the floor to ceiling exceeds three meters, air flow distribution deteriorates and the effect is decreased.

INSTALLATION OF INDOOR UNIT

POSITION OF SUPENSION BOLT
(unit: mm)
A
S-60PE1RS 1060 1100 540
S-71PE1R5
S-100PE1R5
1060 1100 540
S-125PE1R5
S-140PE1R5
B C D
700
700
Uintmm Uintmm
S-60PE1R5 S-60PE1R5
S-71PE1R5 S-71PE1R5
S-100PE1R5 S-100PE1R5
S-125PE1R5 S-125PE1R5
S-140PE1R5 S-140PE1R5
* The Ha is necessary for the access to the * The Ha is necessary for the access to the
top of the unit for repair. top of the unit for repair.
● Apply a joint-canvas between the unit and duct to ● Apply a joint-canvas between the unit and duct to
absorb unnecessary vibration. absorb unnecessary vibration.
● Install the unit leaning to a drainage hole side as a ● Install the unit leaning to a drainage hole side as a
figure for water drainage. figure for water drainage.
TYPE TYPE A A B B
S-60PE1RS S-60PE1RS 130 33.1 290 130 33.1 290
S-71PE1R5 S-71PE1R5
195 35.7 360 195 35.7 360
S-100PE1R5 S-100PE1R5
S-125PE1R5 S-125PE1R5
260 38.2 430 1215 260 38.2 430 1215
S-140PE1R5 S-140PE1R5
1-62
Ha Ha
290 290
360 360
360 360
430 430
430 430
C C D D
118 118
50 50