Panasonic R410A Service Manual page 196

(Continued from previous page)
Item code
Heat exchanger
3C
temperature for cold air
discharge
3d
Fan output switching
Drain pump delayed start
3E
time
Humidifier drain pump
40
setting
45
DC flap operation mode
46
DC flap swing mode
5d
DC fan tap setting
5E
Humidifier ON time
Stop at time set for OFF
5F
timer after operation starts
Timer function change
60
prohibit
62
Smudging control
Item
The heat exchanger temperature control point for prevention of cold
air discharge during heating operation can be changed.
The indoor unit PCB optional output for the fan can be switched
according to the purpose of use.
The drain pump starts after the set time delay after cooling operation
stops.
This specifies the humidifier and drain pump setting.
Changes flap operation to draft reduction mode.
Selects the swing operation mode for the flap.
Sets the DC fan tap according to the purpose of use.
Change the settings data at the same time.
Sets the humidifier output ON time for when the humidifier is
operating.
ON/OFF control is performed during humidifier operation.
This setting therefore sets the ON time per 60-second interval.
This setting enables a function that stops operation when the
amount of time set for the OFF timer has passed after remote
controller operation was started.
This function prohibits changes from being made to the remote
controller time setting.
Smudging control is disabled when 0000 is set.
7-13
Description
7