Matching Up Addresses; Setting Addresses (Cz-Rwsy2/K1 Type) - Panasonic R410A Service Manual

Matching up Addresses

Setting Remote Control Addresses
1. If you press and
2. While holding
Set it to the receiver address switch of the indoor unit you wish to operate.
3. When you release
When you do this, if it corresponds to the receiver's address setting, the buzzer sounds.
Address
Display on the
Remote Control
CZ-RWSU2
Position of The position of the
receiver's receiver's address
(inside indoor switch does not
unit) address matter.
switch
CZ-RWST2
Position of The position of the
receiver's receiver's address
(inside indoor switch does not
unit) address matter.
switch
CZ-RWSL2
Position of The position of the
the operation receiver's address
panel's (inside switch does not
indoor unit) matter.
address switch
CZ-RWSC2
Position of The position of the
the Receiver's receiver's address
Address Switch switch does not
matter.
Setting Addresses (CZ-RWSY2 / K1 Type)
(Setting the address of the indoor unit)
1. First of all, set the address for the remote control with Setting Remote Control Address (See Page 3-12).
2. Press [Emergency Operation]
When you do this, the lamps of the display will blink one after another.
8
3. Press on the remote control.
4. The buzzer will sound and the address of the indoor unit will change to the address displayed on the remote control.
5. If you press [Emergency Operation]
NOTE
• Please do not hold the [Emergency Operation]
blinking one after another.
• Make sure to operate while the indoor unit is stopped.
• The address of indoor unit is set to "ALL" at the time of the shipment.
at the same time , " " will blink.
down, every time you press
, the address that was displayed is set.
1 2 3
4 5 6
of the indoor unit for four seconds or more.
of the indoor unit once, the lamps on the indoor unit's display will turn off.
button of the indoor unit down while the indoor unit's display lamps are
, it cycles from ALL 1 2
1 2 3
4 5 6
8-10
3... 6 ALL.
For 1, 2 and 3, set the switch on the
left and for 4, 5 and 6, to the right.
For 1, 2 and 3, set the switch on the
left and for 4, 5 and 6, to the right.
1 2 3
4 5 6
For 1, 2 and 3, set the switch on the
left and for 4, 5 and 6, to the right.
For 1, 2 and 3, set the switch on the
left and for 4, 5 and 6, to the right.