Paradox digiplex DGP-641 Reference And Installation Manual page 39

Door Left Open:
Event Buffer:
Forced Door:
Digiplex Alarm System has been breached. This
event is logged in the Event Buffer and can be
reported to a Monitoring Station.
Each Access Control door is programmed with a
period of time it is allowed to remain open. Once
the door has been open past this time limit, an
Access Alarm will be triggered (see Access
Alarm).
The user-initiated actions, alarms, and troubles
that occur in the system are saved in the control
panel's memory: the Event Buffer. To view the
events you must enter the Event Record Display
(see Digiplex Reference & Installation Manual).
The Access Control events, however, can only
be viewed through an Access Control Keypad
(DGP-641ACC).
If a protected door was opened without an
"Access Granted" or "Request for Exit" signal, a
silent or audible Access Alarm can be triggered.
If the Access Alarm is programmed to be
audible, the reader assigned to the door can
beep. This event is logged in the Event Buffer,
but can only be seen through an Access Control
keypad (DGP-641ACC) and cannot be reported
to a Monitoring Station unless the door is also
assigned to a zone. If the door is assigned to a
zone, the Forced Door can also trigger a Burglar
Alarm in the Digiplex Alarm System.
Digiplex LCD Keypad 37n