Inspection - Taylor-Dunn TT-316-36 Operation, T Roubleshooting And Replacement Parts Manual

Maintenance, Service, and Repair

Inspection:

Note: There are no repairable parts in this assembly. The parts must be replaced if any damage or wear
is found.
1. Measure the free length of the five springs. Minimum length =0.713"
2. Inspect the splines on the hub and the friction plate for damage.
3. Inspect the inner contact plate and the outer housing where
they come into contact with the friction plate for wear or
damage.
4. Inspect the three dowel pins and their corresponding holes
in the inner contact plate. The dowel pins should be straight
and the holes should be round.
5. Inspect the bearing for excessive play or roughness when
rotated.
6. Inspect the contact surfaces of the magnet and inner contact
plate for damage and flatness.
Brakes
Page 8
Electric motor brake exploded