Disassembling The 3Rd Member - Taylor-Dunn TT-316-36 Operation, T Roubleshooting And Replacement Parts Manual

DISASSEMBLING THE 3RD
MEMBER
1. Make sure the key-switch is in the "OFF"
position, then remove the key.
2. Place the forward-reverse switch in the
center "OFF" position.
3. Confirm the electric park brake is applied.
4. Place blocks under the front wheels to
prevent vehicle movement.
5. Disconnect the main positive and negative
cables at the batteries.
Always use a lifting strap, hoist, and jack
stands, of adequate capacity to lift and
support the vehicle. Failure to use lifting
and support devices of rated load capacity
may result in severe bodily injury.
6. Raise the rear of the vehicle and support with jack
stands.
7. Remove the complete drive from the vehicle.
Removing and Installing the
NOTE: Refer to
Drive Assembly
removing the drive from the vehicle.
8. Place a drain pan under the gear case that is
capable of holding four quarts of oil and drain the
oil from the front gear case and 3rd member.
9. Place the 3rd member on an appropriate stand.
10. Remove the axle shafts
and tubes as
assembly from the 3rd
member by removing
the six axle tube flange
bolts on each axle tube.
11. Remove the primary
reduction gear case.
Disassembly and reassembly of the
Refer to
Primary Reduction Gear Case
on removing the gear case.
Maintenance, Service, and Repair
for information on
an
for information
12. Remove the 12 side
plate bolts, then
remove the side plate.
13. Remove the carrier
bearing adjusting nut
roll pin and adjusting
nut from the side plate.
14. Turn the side plate over
and remove the carrier
bearing race from the
side plate.
15. Remove the differential
assembly from the 3rd
member housing.
16. Remove the carrier
bearing adjusting nut
roll pin from the 3rd
member housing, then
remove the carrier
adjusting nut.
Roll Pin
Transmission
Page 9