Assembling The 3Rd Member - Taylor-Dunn TT-316-36 Operation, T Roubleshooting And Replacement Parts Manual

Maintenance, Service, and Repair
17. Remove the carrier
bearing race from the
3rd member housing.
18. Remove the front
bearing from the input
shaft.
NOTE: The input shaft may
have to be driven out
to perform this
procedure.
19. Remove the input
shaft's shims and
spacer.
20. Remove the pinion
shaft from the 3rd
member.
21. Remove the front and rear pinion bearing races.
22. Inspect all parts for signs of wear or damage.
23. Thoroughly clean all parts.
Transmission
Page 10
ASSEMBLING THE 3RD
MEMBER
1. Temporarily install the pinion gear (hand tighten
only).
2. Install the carrier bearing race ring nuts into the
housing and cover.
Cover
3. Install the carrier bearing races into the housing
and cover.
Cover
4. Place the differential
assembly into the
housing.
5. Tighten the housing
carrier bearing race ring
nut so that the ring gear
is not in binding against
the pinion gear.
6. Remove the differential
assembly.
NOTE: Do not allow the ring nut to rotate.
7. Remove the pinion gear and then reinstall the
differential assembly.
8. Install the cover onto the housing using 4-bolts in
a cross pattern and torque to 45-50 ft-lbs.
Housing
Housing