Adjustment For 45° Angle - Makita LS1017L Technical Information

R
epair
[4] ADJUSTMENT
[4] -2. Adjustment
2 Adjustment for 45° angle
(1) Set blade to the lower dead point and fix it with Pin C.
(2) Remove Sub fence and Right sub fence.
(3) Set 1R207 in the position as shown below and adjust until the gap between blade and 1R207 is cleared.
(e.g.1)
1R207
Gap
If there is a gap in the position circled in line, loosen M6x28
Hex bolt by turning a hex wrench counterclockwise.
M6x28 Hex bolt Hex wrench
Adjust on the opposite side
in the same way.
Completed!
(e.g.2)
Gap
If there is a gap in the position circled in line, tighten M6x28
Hex bolt by turning the wrench clockwise.
After adjustment, move Support arm
from side to side and confirm that
there is no gap.
1R207
Fig. 128
1R207
M6x28 Hex bolt
P 33/ 45
Hex wrench