Makita LS1017L Technical Information page 34

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -10. Working table and Base (cont.)
ASSEMBLING
(5) Insert Pivot shaft to Working table with a plastic hammer.
Working table Pivot shaft
Fig. 119
(7) Push press plate to unlock, and attach Working table
to Base.
Press plate
Base
Fig. 121
(9) Attach two Table inserts while being careful of direction
and fix them with six M4x12 Cross head screws.
Fig. 123
(11) Fix Sub fence and Right sub fence with M10 Locknut.
Right sub fence
M10 Locknut
Fig. 125
Plastic hammer
Working table
Table insert
M4x12 Cross head screw
Sub fence
M10 Locknut
(6) Set two Friction plates to Working table.
Friction plate
Working table
Note:
If Friction plate floats, Working table wouldn't
be stable.
Fig. 120
(8) Tighten and fix M10 Locknut from the back side
of Base. Tighten the Nut so that Working table would
not rattle and moves smoothly.
Big flat washer 10
Working table
Base
Fig. 122
(10) Fix Rip fence with four M8x30 Hex bolts.
Fig. 124
P 31/ 45
Insert the protrusions
on Friction plate
into the holes on
Working table.
M10 Locknut
Rip fence
M8x30 Hex bolt