Rip Fence; Adjustment For The Cutting Range Of Blade - Makita LS1017L Technical Information

Slide compound saw 255mm (10")/ 260mm (10-1/4")
Hide thumbs Also See for LS1017L:
Table of Contents

Advertisement

R
epair
[4] ADJUSTMENT
[4] -2. Adjustment
3

Rip fence

(1) Remove Sub fence and Right sub fence.
(2) Loosen four M8x30 Hex bolts. And is the supporting point for adjustment.
Adjust Rip fence so that the angle between blade and Rip fence is 90°.
1
2
(3) After adjustment, tighten bolts in the following order. Do not tighten them strongly because Rip fence may be out of place.
(4) Confirm that the angle between blade and Rip fence is 90°.
4

Adjustment for the cutting range of blade

(1) Set Up blade guard at the lower dead point. And hold it with hand and adjust the cutting range of blade with M6x25 Hex bolt
so that the edge of blade in the guide fence side and the Handle side is placed inside the range as shown below.
Blade
Table insert
The edge of blade should be
The edge of blade should be
inside the two points.
inside the two points.
2
M8x30 Hex bolt
1
3
5
Blade can be shifted back and forth.
3
4
Rip fence
Fig. 129
Fig. 130
M6x25 Hex bolt
The edge of blade should be
The edge of blade should be
inside the two points.
inside the two points.
Fig. 131
1R208
4
2
Adjusts the cutting range of
blade.
P 34/ 45
Blade

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ls1018l

Table of Contents