Preparation For Adjustment; Adjustment; Adjustment For 90° Angle - Makita LS1017L Technical Information

R
epair

[4] ADJUSTMENT

[4] -1. Preparation for adjustment

Adjust Bevel locking handle as shown below to make it to be shifted by hand.
When Blade is fixed
[4] -2. Adjustment
Adjustment can be carried out following the procedure.
1 Adjustment for 90° angle
(1) Set Up blade guard to the lower dead point and fix it with Pin C.
(2) Set 1R208 in the position as shown below and adjust until the gap between blade and 1R208 is cleared.
(e.g.1)
Blade
1R208
If there is a gap in the position circled in line, loosen M6x28
Hex bolt by turning a hex wrench counterclockwise.
After adjustment, move Support arm from side to side and
confirm that there is no gap.
Support arm
M6x28 Hex bolt
Gap
When adjusting
Fig. 126
(e.g.2)
Hex wrench
If there is a gap in the position circled in line, tighten M6x28
Hex bolt by turning the wrench wrench clockwise.
After adjustment, move Support arm from side to side and
confirm that there is no gap.
Bevel pointer
Fig. 127
Support arm
Blade
Gap
M6x28 Hex bolt
Set Bevel pointer to "0" and tighten
M4x12 Cross head screw.
M4x12 Cross head screw
Completed!
P 32/ 45
Hex wrench