Makita LS1017L Technical Information page 30

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -9. Support arm (cont.)
ASSEMBLING
With Motor housing and blade are attached, adjust tightening force of M10 Locknut so that the body wouldn't fall down
at inclination of 10° and fall down at inclination of 25°.
Bevel scale
Should fall down
(8) After adjustment, put Bowl type plate, two Big flat
washer 10x26x2.5 and Surface bearing.
Big flat washer 10x26x2.5
Bowl type plate
Fig. 97
(10) Tighten M10 Locknut using Bevel locking handle.
Bevel locking handle
Fig. 99
Should not fall down
° ° ° °
° ° 10 10 10 10
° °
25 25
25 25
Bevel pointer
Surface bearing
Locknut M10
Adjustment
Should fall down
Fig. 96
(9) Fix Sliding bracket cover with two M5x20 Cross
head screws.
Sliding bracket cover
Hex nut
(11) Set Bevel locking handle in the direction as shown
below.
Bevel locking handle
M10 Locknut
Adjustment can be done
by tightening M10 Locknut.
M5x20 Cross head screw
Fig. 98
M4x12 Cross head screw
Fig. 100
P 27/ 45