Supply And Delivery - Hamworthy F40V Installation, Commissioning And Operating Instructions

2.0 SUPPLY AND DELIVERY

The boiler is despatched to site as a pre-assembled and tested unit. Each boiler is delivered by a tail lift vehicle
and lowered to ground level. It is the installers responsibility to convey the boiler to the plantroom.
W
D
H
Figure 2.1 - Boiler Packaging
NOTE: The Fleet V series boilers are supplied with protective corner pieces in a shrink fit poly bag. All boilers
can be manoeuvred on a standard pallet truck. However, when handling and manoeuvring the boiler care must
be taken to avoid damage to the casing. The flue system is packaged separately.
The boiler must be kept upright during handling. Care must be exercised to avoid toppling the boiler, as this will
result in damage.
The flue manifold connecting the vertical modules is supplied separately to the boiler - refer to Appendix C.
Warranty
Full warranty assistance will be covered when the appliance is commissioned by Hamworthy Heating Ltd, see
Terms & Conditions for full details.
Hamworthy Heating Ltd will not accept any liability resulting from damage due to tampering, improper
use, handling, installation errors, operation and maintenance. It is important to check for damage upon
receipt of product, which if found must be notified to Hamworthy Heating Ltd immediately.
In the event of failure or breakdown, isolate the equipment and contact Hamworthy Technical Support
Tel - 0845 450 2866
2
HAMWORTHY HEATING LTD FLEET V series 500001213/G