Figure 8.2.1.2 Info Display Parameters - Hamworthy F40V Installation, Commissioning And Operating Instructions

Figure 8.2.1.2 - Info display parameters
The parameters of groups b,C and d can only be displayed
Display level Name of LMU...
variable
General information (Enduser level)
Temperatures (Service level) ¹)
b 0 DiagnoseCode
b 1 TkRuec
b 2 TbwIst2
b 3 Tabgas
b 4 TiAussen
b 5 TaGem
b 6 TaGed
b 7 TvIst
b 8/ b9 Reserved
Process values (Service level) ²)
C 0 Reserved
C 1 IonStrom
C 2 Gebl_Drehz
C 3 Gebl_PWM_AusAkt
C 4 RelModLevel
C 5 Pumpe_PWM
C 6 ek0
C 7/ C8/ C9 Reserved
Setpoints (Service level) ³)
d 0 Reserved
d 1 Tsoll
d 2 TkSoll
d 3 TsRaum
d 4 TbwSoll
d 5 PhzMax
d 6 NhzMax
d 7/ d8/ d9 Reserved
1)
Note 1 Press Info button
2 Press buttons for at least 3 seconds
3 Choose the relevant parameter with buttons
2)
Note 1 Press Info button
2 Press buttons for at least 3 seconds
3 Press button
4 Choose the relevant parameter with buttons
3)
Note 1 Press Info button
2 Press buttons for at least 3 seconds
3 Press button twice
4 Choose the relevant parameter with buttons
Note after about 8 minutes, the display will automatically change to the default display.
HAMWORTHY HEATING LTD
Description
LMU...-internal software diagnostic code
Boiler return temperature
DHW temperature sensor 2
Flue gas temperature
Outside temperature
Composite outside temperature
Attenuated outside temperature
Flow temperature AGU2.500...
Ionization current
Fan speed
Current fan control (PWM)
Relative output
Pump setpoint (PWM)
Control differential
Setpoint of 2-position or modulating controller (PID)
Current boiler temperature setpoint
Room temperature setpoint
DHW temperature setpoint
Maximum degree of modulation in heating mode
Maximum speed at maximum output in heating mode
24
FLEET V series
Not used
Not used
Not used
Not used
500001213/G