How To Install The Option Boards - Panasonic AV-HS410N Operating Instructions Manual

Installation and connections
w How to install the option boards
p
For details, refer to the operating instructions of the option board concerned.
p  The instructions set forth in the operating instructions of the option boards listed below describe the steps to take when the
boards are to be installed in the AV‑HS400AN or AV‑HS400AE.
When reading these instructions, change the wording used for all references to this model and its slots with the actual model
and actual slots.
<Changes in the wording given for option slots and signal lines>
Option boards and wording used in operating instructions
AV‑HS04M1, AV‑HS04M2,
AV‑HS04M3, AV‑HS04M6
AV‑HS04M4, AV‑HS04M5,
AV‑HS04M7
<Changes in wording used for setting switch SW501 of AV-HS04M6>
Wording used in operating instructions
Switch No.
1 Y/C separation mode
(INPUT5, 7)
2
3 Y/C separation mode
(INPUT6, 8)
4
5 NTSC SETUP
6
7 Reserved
8
When an option board (AV‑HS04M1, AV‑HS04M2 or AV‑HS04M6) has been installed in the unit, the settings established by the
selection positions for the following switches are not reflected.
Select the settings using the unit's setting menus.
Wording used in operating instructions
Switch No.
4
Screen position
5
6
Gamut limiter
7
Notes
p  Before installing or removing an option board, turn off the power, and disconnect the power plug.
p  Before coming into physical contact with the option board, touch your hand to metal that has been grounded to discharge
the static electricity in your body.
A safe way to proceed is to wear an anti‑static wrist strap.
The option board may be damaged if you touch the board with static still in your body.
p  Avoid damage to the option board by not dropping it or subjecting it to strong shocks or vibrations.
p  After removing an option board, be absolutely sure to attach the blank panel.
p  When installing or removing an option board, take care not to hurt yourself on the edges or metal parts of the board.
SLOT 1 INPUT 5, INPUT 6
SLOT 2 INPUT 7, INPUT 8
SLOT 1 OUTPUT 3, OUTPUT 4
SLOT 2 OUTPUT 5, OUTPUT 6
When the option board is to be installed in the
AV-HS410
1 Y/C separation mode
(IN A1, IN B1)
2
3 Y/C separation mode
(IN A2, IN B2)
4
5 NTSC SETUP
6
7 Reserved
8
AV-HS410 setting menu
Input menu  Up Converter2 sub menu
Edge Crop Pos
Limiter
(Be sure to ask your dealer.)
When the option boards are to be installed in the
AV-HS410
SLOT A IN A1, IN A2
SLOT B IN B1, IN B2
SLOT A OUT A1, OUT A2
SLOT B OUT B1, OUT B2
Switch No.
12