How To Install The Option Boards - Panasonic AV-HS450E Operating Instructions Manual

1. Installation

1-3. How to install the option boards

The option boards are installed in the mainframe.
For details, refer to the operating instructions of the option board concerned.
 The instructions set forth in the operating instructions of the option boards listed below describe the steps to
take when the boards are to be installed in the AV-HS400AN or AV-HS400AE.
When reading these instructions, change the wording used for all references to this model and its slots with the
actual model and actual slots.
<Changes in the wording given for option slots and signal lines>
Option boards and wording used in operating instructions
AV-HS04M1, AV-HS04M2,
AV-HS04M3, AV-HS04M6
AV-HS04M4, AV-HS04M5,
AV-HS04M7
Changes in wording used for setting switch SW501 of AV-HS04M6
Wording used in operating
instructions
Switch No.
1
Y/C separation mode
(INPUT5, 7)
2
3
Y/C separation mode
(INPUT6, 8)
4
5 NTSC SETUP
6
7 Reserved
8
Notes
 Be absolutely sure to ask your dealer to do the job of installing or removing the option boards.
 Before installing or removing an option board, turn off the power, and disconnect the power plug.
 Before coming into physical contact with the option board, touch your hand to metal that has been grounded
to discharge the static electricity in your body.
A safe way to proceed is to wear an anti-static wrist strap.
The option board may be damaged if you touch the board with static still in your body.
 Avoid damage to the option board by not dropping it or subjecting it to strong shocks or vibrations.
 After removing an option board, be absolutely sure to attach the blank panel.
 When installing or removing an option board, take care not to hurt yourself on the edges or metal parts of the
board.
SLOT 1 INPUT 5, INPUT 6
SLOT 2 INPUT 7, INPUT 8
SLOT 1 OUTPUT 3, OUTPUT 4
SLOT 2 OUTPUT 5, OUTPUT 6
When the option board is to be
installed in the AV-HS450E
Switch No.
1
Y/C separation mode
(IN A1, IN B1)
2
3
Y/C separation mode
(IN A2, IN B2)
4
5 NTSC SETUP
6
7 Reserved
8
15
When the option boards are to be
installed in the AV-HS450E
SLOT A IN A2, IN A1
SLOT B IN B2, IN B1
SLOT A OUT A2, OUT A1
SLOT B OUT B2, OUT B1