[Option] Menu; [On-Screen Setting]; [Computer In] - Panasonic ET-YFB200G Operating Instructions Manual

[OPTION] menu

Select [OPTION] from the main menu, and select the item from the sub-menu.
Refer to "Navigating through the menu" (x page 38) for the operation of the menu screen.
f After selecting the item, press asqw to adjust.

[ON-SCREEN SETTING]

Set the on-screen display.
Setting [OSD DESIGN]
Set the color of the menu screen (OSD).
1) Press as to select [ON-SCREEN SETTING].
2) Press the <ENTER> button.
f The [ON-SCREEN SETTING] screen is displayed.
3) Press as to select [OSD DESIGN].
4) Press qw to switch the item.
f The item is switched every time the button is pressed.
[TYPE1]
[TYPE2]
Setting [OSD OUTPUT]
Set the terminal to output the menu screen (OSD).
1) Press as to select [ON-SCREEN SETTING].
2) Press the <ENTER> button.
f The [ON-SCREEN SETTING] screen is displayed.
3) Press as to select [OSD OUTPUT].
4) Press qw to switch items.
f The item is switched every time the button is pressed.
[DVI-D/DIGITAL LINK]
[DVI-D]
Note
f When the [OSD OUTPUT] is set to [DVI-D/DIGITAL LINK], the menu screen (OSD) is not displayed on any image display device screen
connected to the <DVI-D OUT> terminal or the <DIGITAL LINK OUT 2> terminal if the connection status is as follows. Operate after turning
on the power of the image display device connected to the <DIGITAL LINK OUT 1> terminal.
g Displays (projector or flat panel display) are connected to both the <DIGITAL LINK OUT 1> terminal and the <DIGITAL LINK OUT 2>
terminal.
g Display connected to the <DIGITAL LINK OUT 1> terminal is in standby mode.
If the display connected to the <DIGITAL LINK OUT 1> terminal cannot be turned on due to defect, etc., press and hold the <MENU>
button on the control panel of this device for 3 seconds or longer. The menu screen is forcefully output to the output image of all the output
terminal.
f The menu screen (OSD) is not displayed when the 3D signal is output from the device.

[COMPUTER IN]

Change the setting if the correct image is not displayed when the Y/C signal is input to the device, or when
connected to an external device using the <COMPUTER 1 IN> terminal and the <COMPUTER 2 IN> terminal.
Setting [COMPUTER 1 INPUT SETTING]
Set in accordance to the signal input to the <COMPUTER 1 IN> terminal.
1) Press as to select [COMPUTER IN].
48 - ENGLISH
Chapter 4 Settings — [OPTION] menu
Sets to blue.
Sets to black.
The menu screen (OSD) is displayed in the output image from the <DVI-D OUT> terminal, the
<DIGITAL LINK OUT 1> terminal, and the <DIGITAL LINK OUT 2> terminal.
The menu screen (OSD) is displayed only in the output image from the <DVI-D OUT> terminal.