Connections With Other Devices - Panasonic AV-HS410N Operating Instructions Manual

Installation and connections
w Connections with other devices
p
q Block diagram
p
SDI Input
1 to 8
DVI-D Input
Input
A1, A2
Input
B1, B2
Memory card
~ AC IN
Computer
*1: When external synchronization is selected as the reference signal
setting, the reference signal is input.
When internal synchronization is selected, the reference signal is
output.
*2: When external synchronization is selected as the reference signal
setting, the signals are looped through and output.
When internal synchronization is selected, the reference signal is
output.
Black
FS
Color
SDI IN
BKGD1, 2
1 to 4
VPrc
ColorBar
DbyD
STILL1, 2
CLIP1, 2
FS
UC
SDI IN
5 to 8
VPrc
DbyD
Input
matrix
DVI-D IN
Scaler
AC/DC Power
TALLY/GPI 1 TALLY/GPI 2
Dsub 15 Dsub 15
GPI-IN: 8
GPI-OUT: 19
ALARM OUT: 1
GND: 2
Aux panel
BKGD
CUT, MIX, WIPE, DVE
KEY
CUT, MIX, WIPE, DVE
PinP1, 2
CUT, MIX
DSK Output
CUT, MIX matrix
FTB
AUX 1 to 4
Multi View
WFM
MEM PVW
Option slot A
Option slot B
LAN
RJ45
(*4)
Switching
(*5)
hub
Remote camera
*3: Two sets of the same output signals are distributed from
SDI OUTPUT 1.
*4: Use a crossover cable when connecting the unit and another
device on a 1:1 basis without going through a switching hub.
*5: Use a switching hub.
Proceed with the connections after reading the section entitled
"Network security" (on page 6).
14
SDI OUTPUT
SDI Output
1-1, 1-2
1-1, 1-2 (*3)
SDI OUTPUT
SDI Output
2 to 5
2 to 5
DVI-D OUT
DVI-D Output
Scaler
Output
A1, A2
Output
B1, B2
Reference signal
REF IN/OUT (*1)
REF OUT (*2)
COM EDITOR
Dsub 9 Dsub 9
Editing controller
Aux panel
VTR, etc.