9-3. Auto Restart Function
This indoor unit is equipped with an automatic restarting function which allows the unit to restart operating with
the set operating conditions in the event of a power supply being accidentally shut down.
The operation will resume without warning three minutes after power is restored.
This function is set to work when shipped from the factory.
9-3-1. How to Cancel the Auto Restart Function
To cancel auto restart function, proceed as follows :
Repeat the setting procedure : the unit receives the signal and beeps three times.
The unit will be required to be turned on with the remote controller after the main power supply is turned off.
• When the unit is standby (Not operating)
Operation
Press [RESET] button for more than
three seconds. (Less than 10 seconds)
• When the unit is in operation
Operation
Press [RESET] button for more than
three seconds. (Less than 10 seconds)
The unit is on standby.
↓
The unit starts to operate.
↓
After approx. three seconds,
The unit beeps three times
and continues to operate.
If the unit is not required to operate at this time, press [RESET]
button once more or use the remote controller to turn it off.
The unit is in operation.
↓
The unit stops operating.
↓
After approx. three seconds,
The unit beeps three times.
If the unit is required to operate at this time, press [RESET] button
once more or use the remote controller to turn it on.
- 52 -
Motions
The white indicator is on.
The white indicator flashes
for 5 seconds.
Motions
The white indicator is on.
The white indicator is turned off.
The white indicator flashes
for 5 seconds.