Registering Administrator/Users [Create User] - Riso EZ Series User Manual

REG-LL_EN.book Page 78 Wednesday, September 14, 2011 12:03 PM
Advanced Features

Registering Administrator/Users [Create User]

In order to set the User Management function, the administrator must be registered in advance.
Up to 100 users can be registered (administrator included).
A PIN code and group number are set for each user number.
Note:
• Press the [C] key to cancel the entered value.
• Press [ ] key to return to the previous step.
1
Press the
Its indicator turns on.
Important!:
• If the RISO Network Card (option) is installed,
you will not be able to enter the Custom Setting
mode for up to one minute after turning the
power on.
Note:
• To clear the setting, press the
turn off its indicator.
2
Enter an item number.
The item number is 80.
78
Setting Up User Management
key.
key again to
3
Press the [ ] key.
"U- 0" is displayed with "0" flashing. Go to step 4 to
register a user.
If "0" does not flash, register the administrator. Go
to step 5.
4
Enter the user number (1 to 99) to
register (or change) using the Print
Quantity keys.
To change the registration of the administrator,
enter "0".
5
Press the [ ] key.
After "PASS" is displayed, the machine enters the
PIN code entry mode automatically.
The PIN code that is currently registered flashes.
"0" flashes if the PIN code is not registered.
Note:
• If the entered user number is already regis-
tered, the registered PIN code is displayed.
• To clear this registration, enter "0" and press
the [ ] key. (The clearance of the registration
is applied and operation returns to step 4.)
• To clear the administrator's registration, see
"Clearing all User Management Function Set-
tings". p.78
However, this will clear all User Management
settings such as the user registration.