DSC GS3055-IG User Manual page 31

The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has accepted that the
item complies with minimum conditions for connection to its network. It indicates no endorsement of the product
by Telecom, nor does it provide any sort of warranty. Above all, it provides no assurance that any item will work
correctly in all respects with another item of Telepermitted equipment of a different make or model, nor does it
imply that any product is compatible with all of Telecom's Network Services.
IMPORTANT NOTICE Under power failure conditions, this equipment may not operate. Please ensure that a
separate telephone, not dependent on local power, is available for emergency use.
CAUTION: Changes or modifications not expressly approved by Digital Security Controls Ltd. could void your
authority to use this equipment. This equipment generates and uses radio frequency energy and if not installed and
used properly, in strict accordance with the manufacturer's instructions, may cause interference to radio and
television reception. It has been type tested and found to comply with the limits for Class B device in accordance with
the specifications in Subpart "B" of Part 15 of FCC Rules, which are designed to provide reasonable protection
against such interference in any residential installation. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause interference to television or radio reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
* Connect the alarm control into a different outlet so that alarm control and receiver are on different circuits.
If necessary, the user should consult the dealer or an experienced radio/television technician for additional
suggestions. The user may find the following booklet prepared by the FCC helpful: "How to Identify and Resolve
Radio/Television Interference Problems". This booklet is available from the U.S. Government Printing Office,
WARNING: To satisfy FCC RF exposure requirements for mobile transmitting devices,
a separation distance of 20 cm or more must be maintained between the antenna of this device
declares that the above mentioned GS3055-IG and GS3055-IGW are in compliance with the essential requirements and other
relevant provisions of Directive 1999/5/EC. The complete R&TTE Declaration of Conformity for each Device can be found at
Installation of these systems must be carried out strictly in accordance with the instructions described in this manual,
The above mentioned GS3055-IG and GS3055-IGW had been designed and made to the highest standards of quality and
performance.The manufacturer recommends that the installed system should be completely tested at least once a month. DSC
shall not be responsible for damage arising from improper installation or maintenance by unauthorized personnel.
DSC reserves the right to change the technical specifications of this product without prior notice.
FCC COMPLIANCE STATEMENT
one or more of the following measures:
* Re-orient the receiving antenna
* Relocate the alarm control with respect to the receiver
* Move the alarm control away from the receiver
Washington, D.C. 20402, Stock # 004-000-00345-4.
and persons during device operation.
Hereby, DSC (Digital Security Controls),
www.dsc.com/intl/rttedirect.htm.
The GS3055-IG and GS3055-IGW complie with CEI 79-2 2 Ed.1993.
and in compliance with the local laws and bylaws in force.
31