wsm 05-E2B SERIES Workshop Manual page 84

05-E2B, 05-E2BG, WSM
Cylinder Head and Cylinder Head Gasket (To be continued)
1. Loosen the pipe clamps (1), and remove the water return pipe
(2).
2. Remove the cylinder head screw in the order of (n or r) to (a) and
remove the cylinder head.
3. Remove the cylinder head gasket.
4. Remove the O-ring. (Carbon gasket type only.)
NOTE
• Material of cylinder head gasket has been changed from
carbon to metal. When replacing a cylinder head gasket, be
sure to check with the following table and notes to chose a
correct part.
• The carbon gasket can be used for the engine with the metal
gasket specified using the O-ring (15221-33700).
• The metal gasket cannot be used for the carbon type
specification engine.
• Engine serial number and cylinder head gasket.
Model Type of Gasket
Carbon gasket
D905-E2B / E2BG
Metal gasket
Carbon gasket
D1005-E2B /
E2BG
Metal gasket
D1105-E2B / Carbon gasket
E2BG
Metal gasket
D1105-T-E2B
Carbon gasket
V1305-E2B /
E2BG
Metal gasket
V1505-E2B / Carbon gasket
E2BG
Metal gasket
V1505-T-E2B
Tightening torque Cylinder head screw
(1) Clamp
(2) Return Pipe
S-30
DIESEL ENGINE
Parts Number Serial Number
16221-03310 4R0300 and below
1G032-03310 4R0301 and above
16231-03310 4Z0452 and below
1G040-03310 4Z0453 and above
1E010-03310 4J0010 and below
1G063-03310 4J0011 and above
16271-03310 5E0009 and below
1G078-03310 5E0010 and above
16292-03310 4E9455 and below
16394-03310 4E9456 and above
63.7 to 68.6 N·m
6.5 to 7.0 kgf·m
47.0 to 50.6 ft-lbs
(A) 3 Cylinder
(B) 4 Cylinder
n or r to a : To Loosen
a to n or r : To Tighten
W10205250
KiSC issued 06, 2011 A