wsm 05-E2B SERIES Workshop Manual page 109

05-E2B, 05-E2BG, WSM
Connecting Rod Alignment
NOTE
• Since the I.D. of the connecting rod small end bushing is the
basis of this check, check bushing for wear beforehand.
1. Install the piston pin into the connecting rod.
2. Install the connecting rod on the connecting rod alignment tool.
3. Put a gauge over the piston pin, and move it against the face
plate.
4. If the gauge does not fit squarely against the face plate, measure
the space between the pin of the gauge and the face plate.
5. If the measurement exceeds the allowable limit, replace the
connecting rod.
Connecting rod
Allowable limit
alignment
S-55
DIESEL ENGINE
0.05 mm
0.0020 in.
W10314620
KiSC issued 06, 2011 A