wsm 05-E2B SERIES Workshop Manual page 106

05-E2B, 05-E2BG, WSM
Camshaft Side Clearance
1. Set a dial indicator with its tip on the camshaft.
2. measure the side clearance by moving the cam gear to the front
to rear.
3. If the measurement exceeds the allowable limit, replace the
camshaft stopper.
Factory spec.
Camshaft side
clearance
Allowable limit
Camshaft Alignment
1. Support the camshaft with V blocks on the surface plate at both
end journals.
2. Set a dial indicator with its tip on the intermediate journal.
3. Measure the camshaft alignment.
4. If the measurement exceeds the allowable limit, replace the
camshaft.
Camshaft alignment Allowable limit
Cam Height
1. Measure the height of the cam at its highest point with an outside
micrometer.
2. If the measurement is less than the allowable limit, replace the
camshaft.
Factory spec.
Cam height of intake
Allowable limit
Factory spec.
Cam height of exhaust
Allowable limit
S-52
DIESEL ENGINE
0.07 to 0.22 mm
0.0028 to 0.0087 in.
0.30 mm
0.0118 in.
W10295630
0.01 mm
0.0004 in.
W10296710
28.80 mm
1.1339 in.
28.75 mm
1.1319 in.
29.00 mm
1.1417 in.
28.95 mm
1.1398 in.
W10297880
KiSC issued 06, 2011 A