Turbocharger - wsm 05-E2B SERIES Workshop Manual

05-E2B, 05-E2BG, WSM

(6) Turbocharger

Glow Plug Continuity
1. Remove the glow plug.
2. Measure the resistance with a circuit tester between the glow
plug terminal and the glow plug housing.
3. If the factory specification is not indicated, glow plug is faulty.
Resistance Factory spec.
Engine Stop Solenoid
1. Remove the engine stop solenoid from the engine.
2. Connect the jumper leads from the pulling coil P terminal to the
switch (3), and from switch (3) to the battery positive terminal.
3. Connect the jumper leads from the holding coil H terminal to the
switch (4), and from switch (4) to the battery positive terminal.
4. Connect the jumper leads from the engine stop solenoid body to
the battery negative terminal.
5. When switch (4) is turn on, the plunger pull into the solenoid body
and then turn off the switch (4), the plunger comes out.
6. Turn on the switch (3) then turn on the switch (4), the plunger pull
into the solenoid body and it keep in holding position after turn off
the switch (4).
7. If the plunger is not attracted, the engine stop solenoid is faulty.
IMPORTANT
• Never apply the current for pulling coil more than two
seconds when inspecting.
(1) Connector
(2) Battery
(3) Switch for Holding Coil
(4) Switch for Pulling Coil
Turbine Side
1. Check the exhaust port (3) and inlet port (5) side of turbine
housing (1) to see if there is no exhaust gas leak.
2. If any gas leak is found, retighten the bolts and nuts or replace
the gasket (2) / (4) / (6) with new one.
(1) Turbine Housing
(2) Gasket
(3) Exhaust Port
Compressor Side
1. Check the inlet hose (3) of the compressor cover (4) to see if
there is no air leak.
2. If any air leak is found, change the clamp (2) and / or inlet hoses.
3. Check the intake hose (1) and the clamp to see if there is no
loose or crack.
4. If any loose or crack is found, tighten the clamp or change the
hose to prevent dust from entry.
(1) Intake Hose
(2) Clamp
S-26
DIESEL ENGINE
Approx. 0.9 Ω
0000010726E
P : Terminal for Pulling Coil
H : Terminal for Holding Coil
W1020600
(4) Gasket
(5) Inlet Port
(6) Gasket
W1076917
(3) Inlet Hose
(4) Compressor Cover
W1077032
KiSC issued 06, 2011 A