Front Clamp Reassembly - Mercury Optimax 115 Service Manual

b. Return remote control to neutral. Place a thin piece of paper between idle adjust-
IMPORTANT: The idle stop screw must be touching the stop.
a -
b -
5. Lock the barrel holder in place with the cable latch.

Front Clamp Reassembly

IMPORTANT: Sufficient slack must exist in engine wiring harness, battery cables,
fuel hose, and oil hoses routed between clamp and engine attachment point, to re-
lieve stress and prevent hoses from being kinked or pinched.
1. Place the clamp over the wiring, hoses, and control cables as shown.
a -
b -
c -
d -
e -
g -
90-855347R1 JANUARY 1999
ment screw and idle stop. Adjustment is correct when the paper can be removed
without tearing, but has some drag on it. Readjust cable barrel if necessary.
a
Idle Stop Screw
Idle Stop
Ç Ç Ç
Ç Ç Ç
a
Ç Ç Ç Ç Ç Ç
Ç Ç Ç
g
Battery Cables
Remote Wiring Harness
Warning Gauge Wiring Harness
Control Cables
Oil Hose with Blue Stripe
f - Fuel Hose
Oil Hose
b
b
c
Ç Ç Ç Ç Ç
Ç Ç Ç Ç Ç Ç Ç Ç
Ç Ç Ç Ç Ç Ç Ç Ç
É É É É É Ç Ç Ç
É É É É É
e
É É É
f
OUTBOARD MOTOR INSTALLATION
d
Page 1D-13