RIGHT HAND NON-RATCHETING
IMPORTANT: It is recommended that all seals and gaskets be replaced (as a normal
repair procedure) to assure effective repair.
REMOVAL AND DISASSEMBLY
1. Slide rubber centrifugal slinger up and off driveshaft.
2. Remove water tube guide and seal from water pump cover. (Retain guide for reas-
sembly and discard seal.)
3. Remove (and retain) 3 nuts, one bolt and all washers which secure water pump cover
to gear housing.
4. Using 2 pry bars, lift water pump cover up and off driveshaft.
a
b
c
a -
b -
c -
5. Inspect water pump cover and insert, as outlined in "Cleaning and Inspection," pre-
vious.
6. If inspection of water pump insert determines that replacement is required, follow Step
"a" or "b" (immediately following) to remove insert from water pump cover.
NOTE: Try Step "a" first. If insert cannot be removed with Step "a," use Step "b".
a. Drive water pump insert out of water pump cover with a punch and hammer.
Page 6A-14
Water Tube Guide
Water Tube Seal
Nuts, Bolt and Washers To Be Removed
51874
51874
51874
90-855347R1 JANUARY 1999