Front Clamp Reassembly - Mercury Jet OptiMax 110 Manual

a. Shift outboard into gear a few times to activate the
throttle linkage. Make sure to rotate the propeller shaft
while shifting into reverse.
b. Return remote control to neutral. Place a thin piece of
paper between idle adjustment screw and idle stop.
Adjustment is correct when the paper can be removed
without tearing, but has some drag on it. Readjust cable
barrel if necessary.
IMPORTANT: The idle stop screw must be touching the stop.
a
a - Idle stop screw
b - Idle stop
5. Lock the barrel holder in place with the cable latch.

Front Clamp Reassembly

IMPORTANT: Sufficient slack must exist in engine wiring
harness, battery cables, fuel hose, and oil hoses routed between
clamp and engine attachment point, to relieve stress and prevent
hoses from being kinked or pinched.
OUTBOARD INSTALLATION
b
110
7740
eng