Trim Indicator Gauge Needle Adjustment - Mercury Optimax 115 Service Manual

POWER TRIM

Trim Indicator Gauge Needle Adjustment

1. Turn ignition key to "RUN" position.
2. Tilt outboard to full "IN" position. Needle of trim indicator gauge should be in full "IN"
position.
3. If not, tilt outboard to full "OUT" position to gain access to trim sender and engage tilt
lock lever.
4. Loosen trim sender screws and reposition trim sender.
5. Tighten trim sender screws.
a -
b -
c -
d -
e -
Page 5B-48
c
Trim Sender
Screws, Loosen to Rotate Sender
Turn Sender Counterclockwise to raise needle reading
Turn Sender Clockwise to Lower Needle Reading
Tilt lock lever
b
d
a
e
22744
90-855347R1 JANUARY 1999