Power-On Self-Test; Recoverable Post Errors - Mitsubishi Electric CX series Owner's Handbook Manual

B I O S S e t u p & P O S T
4.
5.
6.
7.

Power-on self-test

Recoverable POST errors

Whenever a recoverable (non-terminal) error occurs during POST,
the BIOS displays an error message describing the problem (the
most usual are described below). After some messages, you may be
prompted to Press <F1> key to resume, <F2> to run Setup or just
Press <F2> key if you want to run Setup.
In general, you should respond to these errors as follows:










7/24 OWNER'S HANDBOOK
Select drive A and use the arrow keys to select the correct
file and then press <Enter>.
When the utility asks for confirmation that you want to flash
the new language into memory, choose Continue with
Programming.
When the utility displays the message upgrade is complete,
remove the diskette and then press <Enter>.
The computer will reboot and the changes will take effect.
Shut down the computer, wait 20 to 30 seconds, and then turn
it on again to see if the problem is still reported.
Check that all external cables are securely connected.
Try running the BIOS Setup utility to reconfigure the system.
If the computer won't start after you make changes in BIOS
Setup, try restoring the original values.
Open up the system unit and check that all internal signal and
power cables are securely connected.
If the problem persists, contact your supplier or authorised
maintainer.
.lng