D r i v e U p g r a d e s
2.
Fitting a 5.25" drive
Fit the new drive into the drive assembly using the special screws
provided. Do not overtighten the screws and put a strain on the
drive casing.
Reassembling the system
1.
2.
6/4
OWNER'S HANDBOOK
Fit the adapter into the drive assembly.
Put the drive assembly back into the system unit and tighten
the screws to secure it to the chassis.
Re-attach the power and signal cables to the original drives and
the riser board. Connect a spare power cable, and the spare
connector on the ribbon cable, between the new drive and the
riser board.
CO MP
ACT
AC T
CO MP
CD ca dd y