Exit Menu - Mitsubishi Electric CX series Owner's Handbook Manual

B I O S S e t u p & P O S T
Removable Devices submenu
This submenu is for configuring the boot sequence for removable
devices.
Options
Legacy Floppy Drives

Exit menu

This menu is for exiting the Setup utility, saving changes, and
loading and saving defaults.
Feature
Exit Saving Changes
Exit Discarding Changes
Load Setup Defaults
Load Custom Defaults
Save Custom Defaults
Discard Changes
7/20 OWNER'S HANDBOOK
Description
Specifies the boot sequence for the removable devices
attached to the computer. To specify boot sequence:
1. Select the boot device with <
2. Press <+> to move the device up the list or <-> to
move the device down the list.
The operating system assigns a drive letter to each
device in the order listed. Changing the order of
the devices changes the drive lettering.
Description
Exits and saves the changes in CMOS RAM.
Exits without saving any changes made in Setup.
Loads the factory default values for all the Setup
options.
Loads the custom defaults for Setup options.
Saves the current values as custom defaults. Normally,
the BIOS reads the Setup values from flash memory. If
this memory is corrupted, the BIOS reads the custom
defaults. If no custom defaults are set, the BIOS reads
the factory defaults.
Discards changes without exiting Setup. The option
values present when the computer was turned on are
used.
 
> or < >.