Mitsubishi Electric CX series Owner's Handbook Manual page 54

Table of Contents

Advertisement

M o t h e r b o a r d
To install memory
To install DIMMs, follow these steps:
1.
2.
3.
4.
5.
6.
7.
8.
9.
5/16
OWNER'S HANDBOOK
Observe the precautions detailed in the 'Safety and Regulatory
Notices' at the front of this handbook.
Turn off and disconnect all peripheral devices connected to the
computer. Then turn off the computer and remove the power
cord.
Remove the computer cover and locate the DIMM sockets,
using the illustration on page 2 of this chapter.
Holding the DIMM by the edges, remove it from its antistatic
package.
Make sure the clips at either end of the socket are pushed away
from the socket.
Position the DIMM above the socket. Align the two small
notches in the bottom edge of the DIMM with the keys in the
socket.
Insert the bottom edge of the DIMM into the socket.
When the DIMM is seated, push down on the top edge of the
DIMM until the retaining clips snap into place. Make sure the
clips are firmly in place.
Replace the computer cover.

Advertisement

Table of Contents
loading

Table of Contents