Install Hood Assembly And Bags - Exmark LZUV52 Operator's Manual

3.2 INSTALL THE HOOD ASSEMBLY AND BAGS
NOTE: Reference the previous assembly diagrams for the Item numbers called out in
the installation instructions.
All Lazer Z XP, Lazer Z XS units and Lazer Z Units with SN 510,000 and Higher:
(For Lazer Z Units with SN 352,000 – 509,999 skip to step 3.2.9)
3.2.1 For units with a 2 post folding ROPS installed: Temporarily remove the ROPS to
allow for installation of the Ultra Vac. Retain the hardware for reuse.
For Lazer Z units SN 510,000 and Higher:
3.2.2 When installing the Ultra Vac onto a liquid cooled Lazer Z, the rear bumper plate
must be removed. Remove rear bumper plate. Reattach the lower side bumper
bars to the vertical "HOT" engine guard shield using two of the original screws,
washers and whizlock nuts removed from the bumper plate.
3.2.3 Remove the lower two screws holding the clutch guard plate ("HOT" engine guard
on liquid cooled units) to the rear frame of the Lazer Z unit.
3.2.4 Install the mount weldment (Item 9) loosely to the rear of the machine using the
two bolts and nuts removed in section 3.2.3.
For Lazer Z XP Lazer Z XS units:
3.2.5 Install mount weldment (Item 9) loosely to the rear bumper using the two holes
provided. Secure using (2) 3/8-16 x 1.00 screws (Item 23), (2) 3/8 spring disk
washers (Item 25) and (2) 3/8-16 whizlock nuts (Item 24).
All Lazer Z XP, Lazer Z XS units and Lazer Z Units with SN 510,000 and Higher:
3.2.6 Install the frame brackets (Item 16) and spacers (Item 17) loosely to the mount
weldment (Item 9). Secure using (2) 3/8-16 x 1.00 screws (Item 23), (2) 3/8 spring
disk washers (Item 25) and (2) 3/8-16 whizlock nuts (Item 24). Make sure that the
raised portion of the spring disk washer faces the head of the screw.
3.2.7 Lazer XP Units SN 439,999 and Lower: Install the frame brackets (Item 16) to the
mounting pads on the Lazer frame. Secure using (4) 3/8-16 x 1.00 screws (Item 23),
(4) 3/8 spring disk washers (Item 25 and (4) 3/8-16 whizlock nuts (Item 24). Make
sure that the raised portion of the spring disk washer faces the head of the screw.
3.2.8 For units with a ROPS installed: Install the frame brackets (Item 16), and ROPS
lower roll bar tubes LOOSELY to the mounting pads on both sides of the Lazer
frame. Use the ROPS mounting hardware, (8) 3/8-16 x 1 ½ screws, (8) 3/8 spring
disk washers and (8) 3/8-16 whizlock nuts. Make sure that the raised portion of
the spring disk washer faces the head of the screw. See Figure 1.
FIGURE 1
LOWER ROLL BAR INSTALLATION
7