Install Removable Weights - Exmark LZUV52 Operator's Manual

Note: The removable weight is heavy. Use care when lifting. Make sure
that you can hold the weight securely before lifting. Use caution when
positioning your hands so that you do not set the weight down on your
hands or fingers.
Lazer Z units SN 440,000 and higher:
3.5.8 Locate the position of the mounting holes by aligning the template (P/N 103-5865)
on the front face of the floor pan as shown in Figure 12. Clamp the template in
place. Using a center punch, mark the positions of the holes on the floor pan. Flip
the template over and repeat on the other end of the floor pan face.
Align template along
these 3 edges.
3.5.9 Drill 3/8" holes at the points marked.
3.5.10 Follow steps 3.5.6 through 3.5.7 for weight installation (See Figure11).
3.6 INSTALL THE REMOVABLE WEIGHTS
Note: The removable weights are heavy. Use care when lifting them. Make sure
that you can hold them securely before lifting them. Use caution when positioning
your hands so that you do not set them down on your hands or fingers.
3.6.1 Assemble the weight brackets (Item 33) to the removable weights (Item 11) using
the 3/8-16 square head bolts (Item 34) and 3/8 whizlock nuts (Item 25).
Unit
Lazer Z 52" Units
Lazer Z 60" Units
Lazer Z 72" Units
Lazer Z XP 60" Units
Lazer Z XP 72" Units
Lazer Z XS 60" Units
Lazer Z XP 72" Units
1
Second 2.0" bracket is included in Ultra Vac XS completion kit 103-7876.
2
Second 2.0" bracket is included in Ultra Vac XP completion kit 103-7420.
FIGURE 11
(All units with a ROPS)
FIGURE 12
1.5" Bracket
1
1
15
2.0" Bracket
1
1
2
1
2
2
2
2
2