Assemble Tubes; Install Weight Plates - Exmark LZUV52 Operator's Manual

3.3.16 Install the belt (Item 13) onto the blower by working it around the impeller sheave.
ALL UNITS:
3.3.17 Mount the blower on the deck by sliding the mounting pin into the tube at the rear
right corner of the deck. Swing the blower closed. Adjust the position of the front
pin to engage the slot in the front of the deck. Use the latch to lock the blower in
this position. Adjust the tension on the latch to hold the blower up to the deck, yet
allow for release by hand.
3.3.18 Pull the spring loaded idler back and slip the belt over the top spindle deck sheave.
3.3.19 Install the plastic belt cover (Item 10). On 60" units the outside end of the cover is
slotted and can slip between the two washers assembled in step 3.3.14. The
plastic knob does not need to be removed. On 72" and 52" units the cover has a
hole, and the plastic knob must be installed after the cover has been positioned.
The original belt cover stud must be removed on 52" units.
3.4 ASSEMBLE THE TUBES
3.4.1 Remove the six screws, nuts, and washers (Items 4, 5, and 6) from the lower tube
(Item 3) and slide the lower and upper tube (Item 2) together. The arrow on the
upper tube should align with the dimple on the lower tube. On 60 and 72 inch
units there are two sets of holes on the lower tube. The first set reached is for
use with Lazer XP and Lazer XS units. The second set reached is for Lazer Z
units. Align the arrow on the upper tube with the dimple on the lower tube and
slide them together until the proper set of holes is reached.
3.4.2 Fasten the upper and lower tubes together using three of the hardware sets
removed from the lower tube in step 3.4.1. The heads of the screws must be inside
the tube to prevent accumulation of grass inside the tube. The washer and the nut
should be installed on the outside of the tube. On Lazer XP and Lazer XS units,
use the remaining three hardware sets to plug the exposed holes in the lower tube.
On Lazer Z units, discard the remaining hardware sets.
3.4.3 Slip the upper end of the tube assembly into the hood opening. Slide the lower
end of the tube assembly over the blower outlet and align the notch with the tube
latch. Latch the tube to the blower.
3.5 INSTALL THE WEIGHT PLATES
3.5.1 The four weight plates (Item 35) must be installed under the front panel of the
floor pan. These weights give proper balance to the machine when the
removable portions of the bagger are removed.
Units with the 2 post foldable ROPS installed require additional mounting plates
(Item 44) and a front weight (Item 43) to be installed. The front weight is
removable and retained by using hairpins (Item 45).
FIGURE 8
13