Exmark LZUV52 Operator's Manual page 17

3.3.12 Using the knob that was removed with the original belt cover stud and the knob
included with the completing kit (Item 40), mount the two belt cover supports (Item
39) to the plastic belt cover (Item 10). Position the belt cover on the mower deck.
The lower ends of the belt cover supports should rest on the outside of the deck
stiffeners. Mark the location of the belt cover support holes on the deck stiffeners.
Remove the belt cover. Center punch and drill 3/8" holes.
3.3.13 Remove the belt cover supports from the belt cover and mount them to the deck
using the 5/16-18 x .75 screws (Item 41) and whizlock nuts (Item 38).
60 AND 72 INCH UNITS ONLY (52 INCH UNITS CONTINUE AT 3.3.21)
3.3.14 Install the belt cover mounting stud (Item 27) included.
For 60 inch units only, install the spacer (Item 29), two 7/16 spring disk
washers (Item 30) and the plastic knob (See figure 7). The knob does not
need to be tightened against the washers at this time.
3.3.15 Install the mounting pin weldment (Item 18) to the blower assembly using the 3/8-
16 x .75 bolts (Item 28) and whizlock nuts (Item 24). Maximum deck clearance
will be provided if the bolts are installed from below the mounting pin. The mount
pin can be installed in two positions. For 60 inch decks the pin should be installed
as far away from the bumper end as possible. For 72 inch decks the pin should
be installed close to the bumper end (See figure 8).
FIGURE 6
BELT ROUTING
FIGURE 7
12