Bagger Removal For Side Discharge - Exmark LZUV52 Operator's Manual

4.2.2 To disengage the deck drive and blower, set the throttle to "midway" position.
Push in on the PTO switch to the "STOP" position to stop the cutting blades and
blower. The cutting blades will require a slightly longer amount of time to come to
a complete stop when the blower is installed on the deck.
4.2.3 To remove the bags, shut off deck drive, stop the engine and wait for all moving
parts to stop. Open the hood and remove the bags by lifting up on the rear of the
bag, then unhooking the front clip. Empty bags by inverting them.
4.2.4 Reinstall bags, close and latch the hood before continuing mowing.

4.3 BAGGER REMOVAL FOR SIDE DISCHARGE:

4.3.1 Shut off the deck drive, stop engine and wait for all moving parts to stop. Remove
key.
4.3.2 Remove the discharge tube by releasing the latch at the blower. Slide the tube
off the blower outlet and remove the upper end from the hood.
4.3.3 Remove the Belt cover by loosening the knobs. For 60" units the outboard knob
does not need to be removed completely to remove the belt cover.
POTENTIAL HAZARD
♦ The deck sheave will become very hot
WHAT CAN HAPPEN
♦ Touching a hot deck sheave can cause severe burns.
HOW TO AVOID THE HAZARD
♦ Allow the deck sheave to cool completely before
removing the belt.
4.3.4 Pull the idler release handle and remove the belt from the upper groove of the
deck sheave.
4.3.5 Unlatch the front end of the blower. Pivot the blower back and lift it off the deck.
4.3.6 Install the discharge chute using the chute pivot pin and hairpin (see figure 13).
4.3.7 Re-install the plastic belt cover and tighten the knobs.
4.3.8 Remove the hair pins and clevis pins holding the hood assembly to the mount
weldment.
4.3.9 Lift the bag and hood assembly off the mount.
CAUTION
22
FIGURE 13
DISCHARGE CHUTE INSTALLATION
17
21