Table of Contents
Advertisement
Settings (Step 2 Network Settings)
2-4 Other Settings Using the "VN-C655U Setup Tool" (10. Black & White Setting) (Continued)
1
Mode
For setting the function on switching from Color
to Black & White mode.
Black & White
Color
Auto
Note
To ensure switching between the Black &
White / Color modes Switching between
Black & White / Color may be performed
according to the brightness of the object
when the mode is set to Auto. However,
this may sometimes fail due to the lighting
condition or angle of view.
In order to ensure proper switching, it is
recommended that switching be performed
by inputting signals from an external
sensor (sold separately) to the alarm
terminal of this camera.
2
Auto Level
For setting the signal level of the object that
will be switched to the Black & White mode
when the [Mode] item is set to "Auto".
Setting is disabled if [Mode] is set to any value
other than "Auto".
Low
: Switch to the Black & White mode
when signal level of the object is low.
Normal: Switch to the Black & White mode
when signal level of the object is
normal.
High
: Switch to the Black & White mode
when signal level of the object is
high.
50
: Black & White mode at all
times. :
Black & White mode at all
times.
: Do not switch to the Black
& White mode.
: Switches automatically to
the Color mode when
brightness level of the
object is high, and to the
Black & White mode when
brightness level of the
object is low.
3
One Push AF
For setting whether to adjust focus automatically
when switching between the Color / Black &
White modes.
ON : Turn on auto focus function.
OFF : Turn off auto focus function.
Note
When in the Black & White mode, this
camera is sensitive to both visible and
near-IR light. As such, images may
become out of focus upon switching from
the Color to Black & White mode,
depending on the type of light source used.
When this occurs, adjust the focus again
in the Black & White mode.
4
Light
Set according to the type of lighting used for
the object when in the Black & White mode.
Normal : Set to this when a normal light is
used.
IR
: Set to this when using an infrared
emission light.
Note
Switching from the Color to Black & White
mode may not function correctly if the "IR"
setting is used under ordinary sunlight or
fluorescent light.
Advertisement
Table of Contents
