Table of Contents
Advertisement
Symptom
Unable to perform camera control
or settings acquired are incorrect
for a span of about 60 seconds
after turning on the power.
Video images cannot be displayed
smoothly.
Forgotten the password upon
enabling the password protection
feature.
Camera turns to another direction
upon initializing.
Unable to select position.
Video images are not displayed.
Delay in the camera's Pan/Tilt
actions.
Zoom does not move to "0"
Causes/Remedial Actions
● About 60 seconds are required for initialization of the
camera to complete upon turning on the power.
To perform camera control or acquire settings, do so by
allowing an interval of at least 60 seconds after turning on
the power.
● Live images may appear in slow motion or loss of frames
may occur when the PC specifications or network
bandwidth is inadequate.
● Repair services will be required to undo the password
protection feature. Please consult your dealer for details.
Please also note that you may be asked to produce
identification cards for security reasons.
● Has the Home position been registered?
Register accordingly if this has not been done.
☞
(
Pages 66, 98)
● Are the positions registered?
Register positions accordingly if this has not been done.
☞
(
Pages 66, 98)
● Is the camera connected to a DC 18 V power supply?
Check connection of the Converter Unit. (
● Is the LAN cable connected?
Check connection of the LAN cable. (
● Is the Pan/Tilt speed set to a small value?
Set this to a larger value. (
● Is the maximum Digital Zoom value set to a value other
than x10?
Zoom to "0" is possible when this is set to x10.
☞
Page 18)
☞
Page 16)
☞
Pages 69, 97)
113
Advertisement
Table of Contents
