Table of Contents
Advertisement
Settings (Step 2 Network Settings)
2-4 Other Settings Using the "VN-C655U Setup Tool" (3. Alarm Setting) (Continued)
Alarm Input
Item
1
Alarm 1/Alarm 2
Mode
Detect Mode
Alarm Output
Go to a preset
position
Return Mode
Interval
Black & White
36
This section describes setting procedures for alarm input.
For selecting whether to enable or disable the input signals.
Set Values : Available, Not Available
For selecting the method for detecting input signals.
Make
: Detect input signals at the "Make" contact point.
Break
: Detect input signals during "Break".
Toggle : Detect input signals at both "Make" and "Break".
For selecting whether to output from the alarm output terminal
when there is alarm input.
Not Available : Do not output from the alarm output terminal.
Alarm Output 1 : Send output from the Alarm Output 1 terminal.
Alarm Output 2 : Send output from the Alarm Output 2 terminal.
Note
•
Unless the alarm output in the "Alarm Output" tab is enabled,
this function will not be activated even if alarm output is
selected in the alarm input settings. (
For setting whether to move to the preset position when there
is alarm input.
Not Available : Do not move to the preset position.
Home
: Move to the home position.
1 to 99
: Move to the preset position.
For setting whether to return the camera that has moved to the
preset position upon the alarm input back to the home position.
Use [Return Interval] to set the time interval before returning
the camera to its home position.
Not Available : Do not return to home position.
Return
: Return to home position.
Event
: Return to home position if operation is not in
the manual mode.
For setting the time interval before the camera returns to its
home position when [Return Mode] is set to "Return".
Set Value : 0 to 65535 sec
For switching from the Color to Black & White mode when there
is alarm input.
Not Available : Do not switch between Black & White/Color mode.
Color
: Color mode at all times.
Black & White
: Black & White mode at all times.
Auto
: Switch automatically between Black & White
and Color mode according to the brightness
of the object.
Note
• When Auto is selected, switching may fail in some cases due to the
lighting conditions or angle of view. In order to ensure that switching is
properly performed, it is recommended that signals from an external
sensor (sold separately) be input to the alarm terminal of this camera.
Function/Set Value
☞
Page 39)
Initial Value
—
Not Available
Make
Not Available
Not Available
Not Available
0
Not Available
Advertisement
Table of Contents
